Hikvision Digital Technology DS-2CD783F-EIZ Manual de instalación descargar pdf (Pagina 11)

Installation Manual of Network Camera

Figure 2-3 Wiring Diagram

2.2 Installation

Box camera I, II, III can be installed to wall or ceiling. Ceiling mounting is taken as an example in this

section; if you adopt wall mounting, you can also take the below procedure as a reference.

2.2.2 Lens Installation

Steps:

1. Remove the back cover from the lens mount.

2. Screw your lens (not provided) clockwise onto the lens mount of the camera.

Note: Please prevent dust from entering between the lens mount and the lens.

Figure 2-4 Install the Lens

3. Plug the cable of the lens to the 4-pin auto-iris interface on the side of the camera.

2.2.3 Wiring

You can take the connection diagram of Figure 2-3 as a reference for connecting peripheral devices:

 Connecting the power supply

The cameras operate using a DC 12V power supply. You can simply plug the DC 12V wire to the

supplied connector.

 Connecting a video output device

The camera with no HDMI interface provides a BNC connector of video output for debugging.

 Connecting audio input/output devices

You can connect an audio input device, such as a pickup, and an audio output device such as a

speaker to the camera.

 Connecting alarms

It provides an alarm input and an output. You can connect alarm input and output devices with

relay controlled circuits to the camera.

 Connecting a remote control device

RS-485 ports (D+, D-) are used for connecting to remote control devices, such as DVRs and

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 94 95

Sin comentarios

Hikvision Digital Technology DS-2CD783F-EIZ Manual de instalación Pagina 11