Hikvision Digital Technology DS-2CD4065F-A Manual de usuario descargar pdf (Pagina 85)

User Manual of Network Camera

Steps:

1. Check the Enable Intrusion Detection checkbox.

2. Click Draw Area, and then draw a rectangle on the image as a defense region.

Note: when you draw the rectangle, all lines should connect end to end to each

other. Up to four areas are supported.

Figure 6-53 Configuring Intrusion Area

You can click Clear to clear the areas you drawn.

The defense region parameters can be set separately.

3. Choose the region to be configured.

 Threshold: Range [0-10s], the threshold for the time of the object

loitering in the region. If you set the value as 0, alarm is triggered

immediately after the object entering the region.

 Sensitivity: Range [1-100]. The value of the sensitivity defines the size of

the object which can trigger the alarm, when the sensitivity is high, a very

small object can trigger the alarm.

 Percentage: Range [1-100]. Percentage defines the ratio of the in-region

part of the object which can trigger the alarm. For example, when you set

the percentage as 50%, half of the object entering the region will trigger

the alarm.

Arming Schedule is configured to set the time you want the function to be

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 133 134

Sin comentarios

Hikvision Digital Technology DS-2CD4065F-A Manual de usuario Pagina 85